Connecting To The Vga Input; Settings For Pc (Rgb); Select Inputs - JVC CO-46LCD-BD Manual De Usario

Connecting to the VGA input

Settings for PC (RGB)

Select inputs

28
Use the VGA input to connect a device with a
VGA port.
S Press the [SOURCE] button or [F4] to open the
<Inputs> selection menu.
S With the [ ] or [ ] button choose the input and
Y B
press the [MENU] button.
You can choose the VGA input also with the
[PC] button.
S Press the [MENU] button to open the main menu.
S
With the button [ ] or [ ]. select the <Setup> menu.
A "
S Select <Inputs> [ ] / [ ] and press the button [
Y B
Auto Setup
S Press the button [ ] to start Auto setup.
"
This function will now attempt to find the optimal pic-
ture settings for the pending signal. During setting
the picture will move slightly back and forth.
H Total
S You can correct the scanning frequency for the PC
picture here. This function is intended only for com-
petent users.
V Pos.
S
Sets the vertical picture position [
V Size
S
Sets the vertical picture size [
H Pos.
S Sets the horizontal picture position [
H Size
S Sets the horizontal picture size [
Phase
S Eliminate flickering and distortions.
S
To close the menu press the red button.
For the selection of an input use the selection menu
<Inputs>.
S Press the button [SOURCE] or [F4] to open the se-
lection menu <Inputs>.
S
Select input [ ] / [ ] and then press the [MENU]
Y B
button.
].
"
] / [ ].
A "
] / [ ].
A "
] / [ ].
A "
] / [ ].
A "
ENGLISH