Bremshey Sport SE7 Manual Del Usuario página 19

CAUTION
– Keep the console away from direct sunlight.
– Dry the surface of the console when it is covered with drops of
sweat.
– Do not lean on the console.
– Only touch the display with the tip of your finger. Make sure that
your nails or sharp objects do not touch the display.
NOTE
– The console switches to standby mode when the equipment is not
used for 4 minutes.
Explanation of buttons
Button
START/STOP
TIME +/-
FREQUENCY +/-
SE7
Explanation
Press the button to start the training. Press the button
again to stop the training. (The equipment is equipped
with two START/STOP buttons, one of which is located
on the bottom of the handlebar for easy access during
the workout.)
Press the button to increase or decrease the time
(0 - 90 s) in steps of 5 seconds. The time can be
adjusted only before the workout. The time is shown
in the time display.
Press the button to increase or decrease the frequency
(20 - 50 Hz) in steps of 5 Hz. The frequency can be
adjusted both before and during the workout. The
frequency is shown in the frequency display.
EN
19