Cleaning And Maintenance; Defects And Malfunctions; Transport And Storage - Bremshey Sport SE7 Manual Del Usuario

EN

Cleaning and maintenance

The equipment does not require special maintenance. The equipment does not
require recalibration when it is assembled, used and serviced according to the
instructions.
WARNING
– Before cleaning and maintenance, remove the mains plug from the
wall socket.
– Do not use solvents to clean the equipment.
▪ Clean the equipment with a soft, absorbent cloth after each use.
▪ Regularly check that all screws and nuts are tight.

Defects and malfunctions

Despite continuous quality control, defects and malfunctions caused by individual
parts can occur in the equipment. In most cases, it will be sufficient to replace the
defective part.
1. If the equipment does not function properly, immediately contact the dealer.
2. Provide the model number and the serial number of the equipment to the dealer.
State the nature of the problem, conditions of use and purchase date.

Transport and storage

WARNING
– Before cleaning and maintenance, remove the mains plug from the
wall socket.
– Carry and move the equipment with at least two persons.
1. Remain standing behind the equipment. Hold the handlebar and tilt the
equipment onto the transport wheels. Move the equipment and carefully put the
equipment down. Place the equipment on a protective base to prevent damage
to the floor surface. Move the equipment carefully over uneven surfaces. Do not
move the equipment upstairs using the wheels, but carry the equipment by the
handlebars.
2. Store the equipment in the upright position. Store the equipment in a dry place
with as little temperature variation as possible.
20 SE7