Prior To First Use - Smith & Nephew SPIDER2 Modo De Empleo

Components
The SPIDER2™ consists of the SPIDER2, (Figure 1), the Foot Pedal, (Figure 2), and the
Switch Drape, (Figure 3).
Figure 1. SPIDER2
1. Quick Connect Release Button
3. Indicator Light
5. Drape Clips
7. Switch Drape Connection Receptacle
9. Dumbbell Joint
11. Battery
13. Clamp Indexing Handle
15. Slender Arm
17. Power Switch
Figure 2. Foot Pedal
1. Foot Pedal Connector 2. Cable
3. Foot Switch 4. Foot Pedal Cover
Instructions for Use
SPIDER2™ Limb Positioner
2. Female Quick Connect
4. Battery Release Button
6. Foot Pedal Connection Receptacle
8. Set Up Button
10. Hinge Joint
12. Clamp Actuating Knob
14. Distal Joint
16. Large Arm
Figure 3. Switch Drape
1. Switch Drape Connector
4. Switch Drape Release Button

Prior to First Use

1. Charge SPIDER2 battery prior to first use, batteries provided are not fully charged.
Refer to Charging Battery section in this document.
2. Once the battery is fully charged, attach the battery to SPIDER2.
3. Turn Power Switch to ON Position (Figure 4); SPIDER2 will be activated and all joints
will lock.
Figure 4. Power Switch States
Unlock Power Switch
Once locked, the joints can be released in one of two ways:
1. Turn the Power Switch to the depressurize position (Figure 4).
2. Press the Set Up Button (Figure 1, Item # 8).
Note: The SPIDER2 Set Up Button is disabled when the Switch Drape and/or Foot Pedal
are plugged in.
English
2. Ribbon 3. Drape Flare
5. Foam Tab
126-99-01 Rev. H
5