Fuse/Circuit Breaker And Wire Sizing - Franklin Electric MonoDrive Connect N3R Manual Del Propietário

Service Entrance
Panel
Use the service
entrance panel
ground ONLY.

Fuse/Circuit Breaker and Wire Sizing

The Listed fuse/Listed circuit breaker size and maximum allowable wire lengths for
connection to the SubDrive/MonoDrive are given in the following tables:
Table 1: Circuit Breaker Sizing and Maximum Input Cable Lengths (in Feet)
Based on a 3% voltage drop
Listed Fuse /
Model Family Listed Circuit
Breaker Amps
15
MonoDrive C
15
15
SubDrive15 C
15
20
MonoDriveXT C
20
20
SubDrive20 C
20
25
SubDrive30 C
25
40
SubDrive50 C
40
XXXX
Highlighted Numbers denote wire with 194 °F (90 °C) insulation only.
NOTE: Not to be used on a Ground Fault Circuit Interrupter (GFCI). If using an externally regulated generator, verify that the
voltage, Hertz and idle speed are appropriate to supply the drive.
All manuals and user guides at all-guides.com
DO NOT run ground wire separate.
Motor ground wire MUST be bundled with motor wires.
AWG Copper Wire Sizes, 167 °F (75 °C) Insulation Unless Otherwise Noted
Nominal
Input
14 12
Voltage
208 80 125
230 95 150
208 70 110
230 85 135
208 - 85
230 - 105
208 - -
230 - 85
208 - -
230 - -
208 - -
230 - -
SubDrive/MonoDrive Connect
10 8 6 4 3
205 315 500 790 980
250 385 615 970 1200
185 280 450 710 880
225 345 550 865 1075
140 220 345 550 680
175 265 425 670 835
115 180 285 450 555
140 220 345 550 680
95 145 235 370 460
115 180 285 455 560
- - 150 235 295
- 115 185 290 360
Pump
Motor
2 1 1/0 2/0
1290 1635 - -
1580 2000 - -
1160 1465 - -
1415 1795 - -
895 1135 - -
1095 1390 - -
730 925 - -
895 1130 - -
605 765 - -
740 935 - -
385 490 610 735
470 600 745 895
15