Declaration Of Conformity - Franklin Electric MonoDrive Connect N3R Manual Del Propietário

SubDrive/MonoDrive Connect

Declaration of Conformity

Model No.
5870205003C
5870205103C
5870205203C
5870205303C
5870205403C
5870205503C
MOTOR OVERLOAD PROTECTION NOTE:
The drive electronics provide motor overload protection by preventing motor current from
exceeding the maximum Service Factor Amps (SFA). Motor overtemperature sensing is not
provided by the drive.
BRANCH CIRCUIT PROTECTION
Integral solid state short circuit protection does not provide branch circuit protection.
Branch circuit protection must be provided in accordance with the National Electrical Code
and any additional local codes, or the equivalent. Drive shall be protected by inverse-time
fuse or Circuit breaker only, rated 300 V maximum, and per the full-load motor output
current rating, as noted in the Fuse/Circuit Breaker and Wire Sizing section.
INTERNAL LITHIUM BATTERY
CAUTION: Never place lithium batteries in mouth. If swallowed, contact your physician or
local poison control center. If battery is damaged, do not use. Battery shall be serviced or
replaced by a qualified serviceman.
Store new batteries only in the manufacturer's containers. Dispose/recycle used and
damaged batteries per local, regional, and national laws and regulations.
MAINTENANCE
Unless needed by the accessory kit or noted within this manual, no additional SubDrive/
MonoDrive maintenance is required.
Wi-Fi MODULE
The Wi-Fi module has been tested and found to comply with part 15 of FCC Rules.
These limits are designed to provide reasonable protection against harmful interference.
This equipment generates, uses, and can radiate radio frequency energy for limited
periods (approx. 15 min.) and, if the drive is not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
4
All manuals and user guides at all-guides.com
Model Description
MonoDrive Connect N3R
SubDrive15 Connect N3R
MonoDriveXT Connect N3R
SubDrive20 Connect N3R
SubDrive30 Connect N3R
SubDrive50 Connect N3R
E184902