Remote Control Mode Operation - Agilent Technologies Turbo-V 1000HT PCB Manual De Instrucciones

Remote Control Mode Operation

If remote signals are used to operate the controller, it must be
programmed for remote operation (see paragraph "FRONT/REMOTE
Selection") and when ready to start, the display shows:
R
S
If the Soft Start has been deselected the display shows:
P
1
With or without Soft Start mode selected the START/STOP and LOW
SPEED front panel push- buttons are inoperative, while the CYCLE
NUMBER and PUMP CURRENT pushbuttons are always active.
Turbo-V 1000HT PCB Controller User Manual / 87-900-906-01 (F)
E A D Y
O F T S
U M P I
2 X X
Technical Information
F O R R
T A R T
S S T A
K R P M
17
Use
E M O T E
R T I N G
255/262