The display shows:
S
S
The Soft Start mode may be deselected/selected only when the pump is
NOTE
stopped.
Turbo-V 1000HT PCB Controller User Manual / 87-900-906-01 (F)
In this routine, the CYCLE pushbutton is used for
choosing/changing the value or condition; the PUMP CURRENT
pushbutton is used to enter and confirm the value. At any time it
is possible to exit this routine by pressing the CYCLE and PUMP
CURRENT pushbuttons at the same time for at least 2 seconds.
O
F
T
S
E
L
E
C
T
where: XXX = YES or NO.
If YES is selected, the Soft Start mode allows the pump to rump-
up the Normal speed within ten steps.
When NO is selected, the Soft Start mode is deselected and the
rump-up of the pump will be done within 360 seconds.
The controller is factory set to YES.
Technical Information
T
A
R
T
I
O
N
:
17
Use
M
O
D
E
X
X
X
239/262