Controller To Pump Connection216 - Agilent Technologies Turbo-V 1000HT PCB Manual De Instrucciones

17 Technical Information
Interconnections
Controller to Pump Connection
To connect the controller to the pump, an appropriate
interconnection cable must be prepared to connect the P10 connector
of the controller with the pump connector.
The following figure shows the pump output connector configuration
where pins:
Figure 13
216/262
A-F = pump temperature sensor
B-C-D = 54 Vac 3-phase output to pump motor stator
E = ground
Controller to pump cable
Turbo-V 1000HT PCB Controller User Manual / 87-900-906-01 (F)