Technical Data; Declaration Of Conformity - CST/BERGER LMPL20 Manual Original

Technical Data

PipeLaser
Article number
Laser class
Laser type
Colour of laser beam
Operating range
Automatic grade adjustment
Grade range
up/down
Automatic lateral alignment
Lateral adjustment range
left/right
Plumb point
Self-levelling range
– Longitudinal axis
– Lateral axis
Horizontal measuring accuracy
at 25 °C
Power supply
– Alkali-manganese batteries
(D cells)
– Ni-MH battery pack
– External DC cable (12 V)
Dimensions
– Length
– Diameter
Operating temperature
Degree of protection
Nitrogen purged and sealed
Weight according to
EPTA-Procedure 01/2003
Remote control
Article number
Operating range
Radio remote control mode*
– Position of the remote control
in the direction of the laser
radiation outlet opening
– Position of the remote control
opposite to the direction of
the laser radiation outlet
opening
Operating range
Infrared radio remote control
mode**
Weight according to
EPTA-Procedure 01/2003
* Measuring tool on top of canal pipe
** Measuring tool in canal pipe partially covered with soil
28 | English
LMPL20
F 034 K62 2N1
3R
635 nm, <7 mW
red
200 m
– 15 ... +40 %
± 15 %
LED-illuminated
– 15 ... +40 %
± 5°
10''
Operating life time,
approx.
60 h
40 h
394 mm
143 mm
– 20 ... +50 °C
IP67
4,8 kg
RC20
F 034 K69 PN1
200 m
46 m
60 m
0,25 kg

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in con-
formity with the following standards or standardization
documents:
EN 61326-1:2006-05,
EN 301489-3:2002-08,
EN 300 220-2:2007-06
according to the provisions of the directives
2004/108/EC, 1999/5/EC.
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 25.08.2009
Assembly
Power Supply of the PipeLaser
For operation of the measuring tool, you can choose
between 3 power supply possibilities:
– Alkali-manganese batteries (D cells)
– Ni-MH battery pack
– External DC cable (12 V)
Inserting/Replacing the Battery
(see figures A1 – A3)
– Release locking knob 3 and pull the battery com-
partment 23 out of the housing.
– Pull both latches on the side of the battery com-
partment outward and lift out the the battery lid 4.
– Remove all 4 batteries and replace them with new
ones. Pay attention to the correct polarity.
– Mount the battery lid again and close both latches.
When mounting, pay attention that the straight
edges of the battery lid face towards the contacts
in the battery compartment.
– Reinsert the battery compartment 23 into the
housing and lock locking knob 3.
Always replace all batteries at the same time. Only use
batteries from one brand and with the identical capac-
ity.
Remove the batteries from the measuring
tool when not using it for extended periods.
When storing for extended periods, the batteries
can corrode and discharge themselves.
Dr. Eckerhard Strötgen
Head of Product
Certification
2 610 A13 727 • 13.10.10