CYCLING PROFILE
SETUP
Except wheel size setting, you could set up all for cycling profile following by the SETUP section in RUNNING PROFILE.
NOTE Make sure bike pod sensor is paired with the watch before cycling.
The setup mainly includes the following parts:
Lap
•
Interval
•
Rest
•
•
HR Zone
Wheel size
•
Wheel size setup
1. In CYCLING mode, press top (1) button to enter, and
the paired sensor icons display on the screen. Press
bottom (3) button to skip if the sensor is added.
2. Press middle (2) button to enter setup mode.
3. Toggle middle (2) button until adjust Wheel size displays.
4. Press top (1) button to enter.
5. Press top (1) button again to increase the value or press bottom (3) button to decrease the value.
6. Press middle (2) button to confirm selection.
USEFUL REFERENCE
About Bike Wheel Size
Match the ETRTO or wheel size diameter printed on the wheel with the wheel size setting at the right hand column of the table below. Input the relevant wheel size setting
number after bike pod is paired.
ETRTO
25-559
23-571
35-559
37-622
47-559
20-622
52-559
23-622
25-622
28-622
32-622
42-622
47-622
NOTE Wheel sizes on the above table are for reference only as wheel size depends on the wheel type and air pressure.
VIEW EXERCISE RECORD DURING CYCLING
You could start cycling by following the steps below, and if you set up the Interval, the distance or timer will count down.
NOTE Make sure the watch has enough memory, otherwise no memory displays when you press button after CYCLING mode.
To view cycling records:
1. In CYCLING mode, press top (1) button to enter, and the paired sensor icons display on the screen. Press bottom (3) button to skip the searching mode if the sensor is added.
Wheel size diameter (inches)
26 x 1.0
650 x 23C
26 x 1.50
700 x 35C
26 x 1.95
700 x 20C
26 x 2.0
700 x 23C
700 x 25C
700 x 28
700 x 32C
700 x 40C
700 x 47C
11
Wheel size setting (mm)
1884
1909
1947
1958
2022
2051
2054
2070
2080
2101
2126
2189
2220