2. Press top (1) button to enter for selecting an exercise proﬁle, toggle middle (2) button to select your desired proﬁle, then press top (1) button to start uploading.

3. Tap CONNECT WITH WATCH on the mobile device to initiate synchronization while pressing top (1) button again on the watch. Done displays on the watch until

successfully connect and upload.

NOTE If the connection is failed, the watch automatically attempts to synchronize again.

SCREEN MESSAGE

UPDATE SYSTEM

You could update the watch to an advanced system that Oregon Scientiﬁc offers in the future through the application, if applicable.

In the application, you can be noticed in INFO page by a message popped up, or browsing NEW VERSION AVAILABLE! at the

below of the page.

1. In CONNECT mode, press top (1) button to enter and toggle middle (2) button to enter update system display.

2. Toggle top (1) button to enter below screens in order. The current watch system will be erased after your conﬁrmation.

NOTE If the system updating fails, Failed displays, and the screen goes back to start system update for your next trial.

NOTE In INFO page, you can browse the WATCH ID, VERSION and LAST SYNC TIME.

SOLUTION

Without the phone application "Ssmart", once you accidentally press the wrong button while updating

the system on the watch, please follow the steps below to resume the updates.

1. Remove the battery from the compartment and wait for at least 15 seconds before re-installation.

2. Return the battery to the compartment. Make sure the battery should have enough energy;

otherwise please insert a new battery instead of the original one.

3. Secure the lid by using the coin to make the lid back into the place. start system update displays

on the screen.

4. Start your phone with the application "Ssmart".

5. Tap on

to enter SYNC page.

6. Tap on CONNECT WITH WATCH, and then press the top (1) button on the watch. system update

and please wait display on the screen.

7. The watch and the application begin to synchronize and the system starts updating. Once the watch

completes updating, the screen turns off for about 1 minute, then goes back to the idle time mode.

SENSOR SETUP

With different sensor devices paired with the watch, the watch can be maximized to the highest performance for your exercise target, including chest belt and bike pod

(purchased separately). You can add a sensor before or after downloading exercise proﬁles.

no memory

pls change

batt.for

update

Synchronization in progress

Synchronization successful

Synchronization failed. Watch attempts to synchronize again.

There is no data in the watch.

The watch battery is low and needs to be replaced

��

SYNC