Equipment Setup And Use; Prior To Use; Setup - Hillrom A-10052 Manual Del Usuario

INSTRUCTIONS FOR USE
3

Equipment Setup and Use:

Prior to use:

a. Inspect the product looking for any visible damage or sharp edges that could
be caused by a drop or impact during storage.
b. Make sure product has been properly cleaned and disinfected and wiped dry
prior to each use.
c. The patient for any pre-existing conditions that might contraindicate the use of
leg positioning devices (e.g. recent hip surgery).

Setup:

a. Squeeze the Release Handle. This action rotates the attachment blade for easy
set-up on the surgical table rail.
b. Position clamps adjacent to the patients' hip.
c. Attach stirrup to the table rail.
CAUTION: Avoid pinching fingers between rail and clamp body.
WARNING:
A-10052: Slide Blade into the slot on the

top of the rail clamp. Shown in below
Figure.
WARNING: Once the stirrup is placed on the rail, the clamp/socket must be
tightened securely before use.
d. Pre-position the stirrup boots, by loosening the Boot-Locking Mechanism and
sliding the Boot along the rod until the top end (calf portion) of the Boot is
located approximately at the patient's mid-calf. Tighten the Boot Locking
Mechanism securely.
e. Pre-position the stirrup boots, by loosening the Boot-Locking Mechanism and
sliding the Boot along the rod until the top end (calf portion) of the Boot is
located approximately at the
Mechanism securely. Repeat above procedure for the other stirrup.
Document Number: D-720334
Version: D
patient's mid-calf. Tighten the Boot Locking
Page 13
Issue Date: 06 MAR 2020
Ref Blank Template: 80025117 Ver. F