Data Transfer - Accu-Chek Performa Instrucciones De Uso

3
Meter Memory, Setup and Data Transfer

Data Transfer

Transferring Results to a Computer
We offer a variety of software to help you transfer your results. For information on Accu-Chek software,
contact Roche.
You can transfer your stored results to a computer to track, identify patterns, and print.
w WARNING
Transferring data to a computer from meters used for multiple-patient testing is NOT
recommended since individual patient results cannot be identified.
Transferring Data Directly to a Computer Using Specialised Software and an Infrared Cable
1. Install the software according to the instructions.
2. To transfer the results to a computer, connect the infrared cable according to the instructions.
3. Run the software program and follow the instructions for data transfer. Make sure the software is ready
to accept data from the meter.
4. With the meter off, press and hold both
5. Locate the infrared (IR) window on the top of the meter.
6. Locate the IR window on the infrared cable.
7. Place the meter on a flat surface. Point the 2 IR windows toward each other. They should be 3–10 cm
apart.
8. Do not move the infrared cable or meter during the data transfer.
9. Follow the prompts on the software.
10. The software program may shut off the meter automatically when the data transfer is complete. Should
this occur, follow the prompts on the computer screen.
Document Name: ART-07022590007
Document Number: 0000109119
Version: 1.0
This copy will not be updated. Verify the validity of this version in the appropriate electronic repository.
26
78120_07022590007_EN.indb 26
and until 2 arrows on the display alternately flash.
NOTE
• If the data did not transfer successfully, try again.
Contact Roche if you still have problems.
Lifecycle Status: Effective
• To make the most of the transfer feature, make sure the
meter is set to the correct time and date.
4/23/2019 1:56:41 PM
Confidential
Valid from: 02-Aug-2019
Page 28 of (180) page(s)