Installation And Operation Of The Bwt Ro App; Installation Of The App; Operating The App; Troubleshooting - BWT bestaqua 14ROC Coffee Instrucciones De Montaje Y Manejo

 NOTE!
After each filter cartridge replacement, flush the device for 5 minutes (approx. 10 l).
f
If the permeate volume flow falls, the membrane element must be replaced. Replacement is recommended after 12 months in all cases.
f

5.5 Installation and operation of the BWT RO app

5.5.1 Installation of the app

If the BWT RO app is not yet installed on your mobile phone, please scan the QR code below.
This will take you to the website where you can download the app. The app can also be down-
loaded under the following internet address: www.bwt-wam.com
 PLEASE NOTE!
Ensure that Bluetooth is activated on your end device.
f
When installing the app for the first time on an iOS end device, download the app and proceed as follows to activate it: Settings / Gener-
f
al / Device Management / BWT Aktiengesellschaft / Trust BWT Aktiengesellschaft
The app is a purely offline application. No data is transmitted to BWT.
f

5.5.2 Operating the app

You will find the operating instructions for the BWT RO app attached (Appendix).

6 Troubleshooting

6.1

Overview of the status and alarm LEDs

Status
working
ready
working
working
Service
Fault
LED colour
green light
green flashing light
yellow light
blue light
red light
red light
(constant or flashing)
Device status
RO device in production
Device is on standby
WCF alarm triggered
Mobile device connected to RO via Bluetooth
Service required
(Chapter 5.5.4)
Error message displayed in app
21
(Chapter 6.2)