Cleaning The Engine; Storage; Warranty - Cub Cadet 21AB45M5603 Instrucciones De Funcionamiento Originales

Operating manual for engine

Cleaning the engine

If the engine has already been
running, leave it to cool down for
at least one hour before cleaning.
Regularly remove accumulated dirt
from the engine. Clean the finger
guard and the area around the
exhaust. Use a brush or
compressed air.
`~ìíáçå>
aç=åçí=ÅäÉ~å=íÜÉ=ÉåÖáåÉ=Äó=ëéê~óáåÖ=
áí=ïáíÜ=ï~íÉêI=~ë=íÜÉ=ÑìÉä=ã~ó=ÄÉ=
Åçåí~ãáå~íÉÇK=t~íÉê=Ñêçã=~=Ö~êÇÉå=
ÜçëÉ=çê=ÜáÖÜJéêÉëëìêÉ=ÅäÉ~åÉê=ã~ó=
éÉåÉíê~íÉ=íÜÉ=ÉñÜ~ìëí=çéÉåáåÖ=~åÇ=
Ç~ã~ÖÉ=íÜÉ=ÉåÖáåÉK
!
a~åÖÉê>
aáêí=ïÜáÅÜ=Ü~ë=~ÅÅìãìä~íÉÇ=~êçìåÇ=
íÜÉ=ÉñÜ~ìëí=ã~ó=Å~íÅÜ=ÑáêÉK=
`ÜÉÅâ ~åÇ=ÅäÉ~å=íÜÉ=~êÉ~=ÄÉÑçêÉ=
ìëáåÖ=íÜÉ=ìåáíK

Storage

Engines which are stored for longer
than 30 days should have an empty
fuel tank in order to prevent the
formation of residue in the fuel
system, especially on important
parts of the carburettor.
If storage is from 30 to maximum
90 days, a stabiliser can be added
to the fuel. Contact your dealer or
the customer service centre.
Leave the engine running until
the tank runs out of fuel and the
engine stops.
Change the oil.
See "Changing the oil".
Remove the spark plug and pour
approx. 15 ml of engine oil into the
cylinder. Re-install the spark plug
and slowly pull the starter cable to
distribute the oil.
Remove dirt around the engine,
under the finger guard and under,
around and behind the exhaust.
Apply a light film of oil to areas
which could rust.
Store in a clean, dry and well
ventilated area away from units
which operate with a flame or
a warning lamp, e.g. heating
equipment, boilers or tumble-
dryers. Areas should also be
avoided in which a spark-
generating electric motor is situated
or in which electric tools are used.
If possible, storage areas with
a high air humidity should not be
selected either, as this promotes
the formation of rust and corro-
sion.
Store the unit on a flat surface.
If the unit is on an incline, fuel or oil
may run out.
Procedure following
prolonged storage
Check the engine as described in
the section "Checking the engine
before start-up".
If the fuel was drained prior to
storage of the unit, fill up the tank
with fresh petrol. If a petrol can is
used for refuelling, ensure that it
contains fresh petrol.
If the cylinder was oiled during
storage, the engine generates
a little smoke when it is started.
This is normal.

Warranty

The warranty regulations issued by
our company or the importer are
valid in all countries. We shall repair
any faults on your unit free of charge
in accordance with the warranty,
provided the fault was due to
defective materials or manufac-
turing. If claiming under the
warranty, please contact your seller
or your nearest branch.
English
9