Starting The Engine - Cub Cadet 21AB45M5603 Instrucciones De Funcionamiento Originales

English
Use only 4-stroke oil belonging to
classification SF/SG/SH/SJ or
higher.
Select the viscosity of the oil from
the following table depending on the
outside temperature:
a) Single viscosity
b) Multiple viscosity
SAE 10W-30 is recommended for
general use in the normal tempera-
ture range. If oil with an individual
viscosity is used, a viscosity should
be selected from the table for the
average temperature in the
application area.
`~ìíáçå>
fÑ=~å=áåÑÉêáçê=çáä=çê=~å=çáä=Ñçê=OJëíêçâÉ=
ÉåÖáåÉë=áë=ìëÉÇI=íÜÉ=ëÉêîáÅÉ=äáÑÉ=çÑ=
íÜÉ=ÉåÖáåÉ=ã~ó=ÄÉ=Ç~ã~ÖÉÇK
Checking the oil level
`~ìíáçå>
tÜÉå=ÅÜÉÅâáåÖ=íÜÉ=çáäI=ÉåëìêÉ=íÜ~í=íÜÉ=
ìåáí=áë=çå=~=äÉîÉä=ëìêÑ~ÅÉ=~åÇ=íÜ~í=íÜÉ=
ÉåÖáåÉ=áë=ëïáíÅÜÉÇ=çÑÑK
Fig. 2
Unscrew the oil filler cap (1)
and wipe the dip stick.
Insert the dip stick into the filler
neck, but do not screw in.
If the level is too low, slowly pour
in a little oil up to the upper "max"
mark on the dip stick.
Before starting the engine, firmly
screw in the dip stick.
`~ìíáçå>
aç=åçí=éçìê=áå=íçç=ãìÅÜ=çáäK=fÑ=íÜÉ=
ÉåÖáåÉ=áë=çîÉêÑáääÉÇ=ïáíÜ=çáäI=íÜáë=ã~ó=
êÉëìäí=áå=ÉåÖáåÉ=Ç~ã~ÖÉI=ëãçâÉ=
Ñçêã~íáçåI=ëí~êíáåÖ=ÇáÑÑáÅìäíáÉë=çê=
ëççíÉÇ=ëé~êâ=éäìÖK
6
Recommended fuels
!
a~åÖÉê>
Ó råÇÉê=ÅÉêí~áå=ÅçåÇáíáçåë=éÉíêçä=
áë ÉñíêÉãÉäó=Ñä~ãã~ÄäÉ=~åÇ=
ÉñéäçëáîÉK
Ó oÉÑìÉä=çåäó=áå=ïÉää=îÉåíáä~íÉÇ=
ëìêêçìåÇáåÖë=~åÇ=ïáíÜ=íÜÉ=ÉåÖáåÉ=
ëïáíÅÜÉÇ=çÑÑK=aç=åçí=ëãçâÉ=åÉ~ê=
íÜÉ=ÑìÉä=í~åâ=çê=áå=íÜÉ=ÑìÉä=ëíçê~ÖÉ=
äçÅ~íáçå=~åÇ=ÉñíáåÖìáëÜ=~ää=áÖåáíáçå=
ëçìêÅÉëK
Ó aç=åçí=çîÉêÑáää=íÜÉ=éÉíêçä=í~åâ=
EíÜÉêÉ=ãìëí=ÄÉ=åç=ÑìÉä=áå=íÜÉ=ÑáääÉê=
åÉÅâFK=^ÑíÉê=êÉÑìÉääáåÖI=ÉåëìêÉ=íÜ~í=
íÜÉ=ÑìÉä=Å~é=áë=ÅäçëÉÇ=~åÇ=
ëÉÅìêÉÇK
Ó tÜÉå=êÉÑìÉääáåÖI=Çç=åçí=ëéáää=~åó=
ÑìÉäK=péáääÉÇ=ÑìÉä=çê=éÉíêçä=î~éçìêë=
ã~ó=áÖåáíÉK=fÑ=ÑìÉä=ï~ë=ëéáääÉÇI=
ÉåëìêÉ=íÜ~í=íÜÉ=~êÉ~=áë=ÇêáÉÇ=
ÄÉÑçêÉ=êÉëí~êíáåÖ=íÜÉ=ÉåÖáåÉK
Ó ^îçáÇ=êÉéÉ~íÉÇ=çê=éêçäçåÖÉÇ=ëâáå=
Åçåí~Åí=~åÇ=áåÜ~ä~íáçå=çÑ=íÜÉ=
î~éçìêëK
!
oáëâ=çÑ=ÉåÖáåÉ=Ç~ã~ÖÉ>
Ó aç=åçí=ãáñ=ÑìÉä=~åÇ=çáäK
Ó rëÉ=ÅäÉ~åI=ÑêÉëÜ=~åÇ=ìåäÉ~ÇÉÇ=
ÑìÉä=çåäóK
Ó rëÉ=ÑìÉä=ïáíÜ=~å=çÅí~åÉ=åìãÄÉê=
çÑ UT=çê=ÜáÖÜÉê=çåäóK
Ó píçêÉ=ÑìÉä=áå=èì~åíáíáÉë=ïÜáÅÜ=
Å~å ÄÉ=ìëÉÇ=ïáíÜáå=PM Ç~óëK
Ó båëìêÉ=íÜ~í=åç=ÇáêíI=Çìëí=çê=ï~íÉê=
ÖÉíë=áåíç=íÜÉ=í~åâK
Checking the petrol level
`~ìíáçå>
_ÉÑçêÉ=êÉÑìÉääáåÖI=äÉ~îÉ=íÜÉ=ÉåÖáåÉ=íç=
Åççä=Ççïå=Ñçê=~í=äÉ~ëí=íïç=ãáåìíÉëK
Fig. 3
Before removing the tank cover (1)
and refuelling, clean the area
around the inlet nozzle.
Fill the tank up to approx. 3 cm
below the neck of the inlet nozzle
or until the fuel has reached the
maximum level according to the
indicator (2 depending on model),
thereby allowing the fuel to expand.
Operating manual for engine

Starting the engine

Fig. 4
! a~åÖÉê>
hÉÉé=Ü~åÇë=~åÇ=ÑÉÉí=~ï~ó=Ñêçã=
ãçîáåÖ=é~êíëK=aç=åçí=ìëÉ=~åó=
éêÉëëìêáëÉÇ=ëí~êíáåÖ=~áÇëK=
qÜÉ=î~éçìêë=~êÉ=Ñä~ãã~ÄäÉK
! a~åÖÉê>=
cçääçï=~ää=çéÉê~íáåÖ=áåëíêìÅíáçåë=áå=
íÜÉ=çéÉê~íáåÖ=ã~åì~ä=Ñçê=íÜÉ=ìåáí=
çå ïÜáÅÜ=íÜáë=ÉåÖáåÉ=áë=ãçìåíÉÇK
Note
– Some models have no throttle
and the speed is adjusted auto-
matically. The engine always runs
at optimum speed.
– Even if the engine is warm, it may
be necessary to actuate the
choke.
– Some models have no choke.
The engine is automatically set to
the particular starting process.
– Leave the engine to warm up for
several minutes before working
with the unit.
Move the throttle (1) – if fitted – on
the engine or steering handle (for
units with throttle remote control –
depending on model) to position
.
Actuate the choke
(if the engine is cold):
– Move choke (2) to position
/ON.
Stand behind the unit.
Pull gently on the starter handle
until it begins to resist. Then pull
quickly and forcefully to overcome
the compression, prevent recoil
and start the engine. If required,
repeat.
`~ìíáçå>
aç=åçí=äÉí=íÜÉ=ëí~êíÉê=Ü~åÇäÉ=ëéêáåÖ=
Ä~Åâ=~Ö~áåëí=íÜÉ=ÉåÖáåÉK=äçïäó=ÖìáÇÉ=
áí=Ä~Åâ=íç=éêÉîÉåí=Ç~ã~ÖáåÖ=íÜÉ=
ëí~êíÉêK=aç=åçí=éìää=çå=íÜÉ=ëí~êíÉê=
Ü~åÇäÉ=ïÜÉå=íÜÉ=ÉåÖáåÉ=áë=êìååáåÖK
When the engine has started or
as soon as the engine has warmed
up, slowly move the choke to
/OFF.