Battery Installation - TOHATSU MFS 9.9E Serie Manual Del Propietário

Ocultar thumbs Ver también para MFS 9.9E Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Install the remote control box in a position
where it is easy to reach and operate the
controls.
Make sure there are no obstacles that can
interfere with the operation of the remote
control cable.
ENOW00850-0
Remote control cable length
Measure the distance from the remote
control box to the outboard motor where
the remote control cable should be routed.
Prepare a cable that is 300-450mm (11.8-
17.7in) longer than the measured distance.
Temporarily pull the cable along the
intended cable route to check its length is
sufficient.
Connect the remote control cable to the
engine, then run the cable to the remote
control box, making sure it is not sharply
bent, too taut and free from obstructions
that could interfere with steering.
ENOM00029-A

3. Battery installation

ENOW00012-A
WARNING
Battery electrolyte contains sulfuric acid
and thus is hazardous, causing a burn if it
All manuals and user guides at all-guides.com
comes in contact with your skin, or poison-
ous if swallowed.
Keep battery and electrolyte away from
reach of children
When handling the battery, be sure to:
In case battery electrolyte comes in con-
tact with:
In case battery electrolyte is swallowed:
ENOW00013-B
ENOF00842-0
Battery generates explosive hydrogen gas.
Be sure to:
ENOW00014-0
INSTALLATION
Read all warnings shown on the battery.
Prevent electrolyte in contact with of
your body. Contact can cause serious
burn or, loss of sight. Use safety glasses
and rubber gloves.
Skin, flush thoroughly with water.
Eye, flush thoroughly with water, and
then seek immediate medical treatment.
Seek immediate medical treatment.
WARNING
Charge the battery in a well-ventilated
place.
Place the battery away from any source
of fire, sparks and open flames such as
burners or welding equipment.
Do not smoke near the battery.
Do not charge the battery when the
electrolyte level is low. Otherwise, the
battery will be damaged and may cause
malfunction.
CAUTION
Make sure that the battery leads do not
get stuck between the outboard motor
and boat when turning, etc.
The starter motor may fail to operate if
the leads are incorrectly connected.
Be sure to correctly connect the (+) and
(—) leads. If not, the charging system
will be damaged.
Do not disconnect the battery leads
from battery while the engine is operat-
23
5

Publicidad

Tabla de contenido
loading

Tabla de contenido