Fuel System Draining - TOHATSU MFS 9.9E Serie Manual Del Propietário

72
INSPECTION AND MAINTENANCE
ENOW00066-0
Do not carry or store outboard motor in
any of positions described below.
Otherwise, engine damage or property
damage could result from leaking oil.
ENON00021-A
Note
If the outboard motor must be laid down
be sure drain the fuel and engine oil,
then the outboard motor on a cushion
as shown in the drawing below (See
page 72 and page 50).
Elevate power unit 2 inches to 4 inches if
traveling to avoid oil spillage.
10
ENOM00950-0
Adding a fuel stabilizer
When adding a fuel stabilizer additive
(commercially available), first fill the fuel
tank with fresh fuel. If the fuel tank is only
partially filled, air in the tank can cause the
fuel to deteriorate during storage.
All manuals and user guides at all-guides.com
CAUTION
ENOF01219-1
ENOF01221-1
1. Before adding fuel stabilizer additive,
d r a i n t h e v a p o r s e p a r a t o r ( S e e
page 72).
2. Follow the instructions on the label
when adding the fuel stabilizer additive.
3. After adding the additive, let the out-
board motor run in the water for 10
minutes to make sure any old fuel in
the fuel system has been completely
replaced by the fuel with additive.
4. Turn the engine OFF
ENON00891-0
Note
If your motor is used occasionally, it is rec-
ommended to use a good fuel stabilizer in
every tank of fuel and keep the container full
to reduce condensation and evaporation.
ENOM00970-E

Fuel system draining

ENOW00936-0
WARNING
For details on handling fuel, contact an
authorized dealer.
Fuel and fuel vapors are extremely flamma-
ble and can be explosive.
If fuel is spilled, wipe it up immediately.
Keep the fuel tank well away from
sources of ignition, e.g. sparks or open
flames
Perform all work outdoors or in a well
ventilated place.
ENOW00097-0
WARNING
Be sure to use cloth to remove fuel remain-
ing in the cowl and dispose of it in accor-
dance with local fire prevention and
environment protection regulations.