Lubricating The Machine; Electromagnetic Brake; Important - Nilfisk Liberty SC50 Instrucciones De Uso

6/2020

LUBRICATING THE MACHINE

Apply grease to (or grease fitting locations) (AA):
Use grease type Lubriplate 730-2 or equivalent
®
• Steering Chain
• Drive Wheel Chain
• Drive Chain Idler Sprocket (grease fitting)
FIGURE 4-4

ELECTROMAGNETIC BRAKE

See Figure 4-5. The drive wheel motor has a built in electromagnetic brake that is engaged whenever the machine Power Switch (B) is OFF or
the Go Pedal (24) is not being pressed, machine in neutral. This brake can be manually overridden if necessary by reaching up around the back
of the front drive wheel and rotating the Brake Arm (AC) as shown. This should only be done in the event the machine needs to be pushed or
pulled. Remember to re-engage the brake arm after the machine is moved.
CAUTION!
Disconnect the batteries before
reaching into this area and rotating the
brake arm. Severe injury could occur if
steering components suddenly move.
IMPORTANT: The steering is controlled
electronically rather than by mechanical
linkage. This means that whenever the
power is off the machine cannot be steered
using the steering wheel.
12/2017
INSTRUCTIONS FOR USE
AA
AA
AA
56091204 - Nilfisk Liberty SC50
FIGURE 4-5
AC
ENGLISH - A
A - 55