Lavorwash FIT 35B Instrucciones Para El Uso página 45

13. Fill with clean water, at a temperature no
higher than 50C° and no lower than 10C°.
14. Add the liquid detergent to the solution
tank in the concentration and manner
indicated on the detergent manufacturer's indicated on the detergent manufacturer's
label .
ATTENTION: the formation of excess
foam could damage the vacuum motor, so
use only the minimum amount of detergent
necessary.
ATTENTION: always use detergents
whose manufacturer's label indicates their
suitability for scrubbing machines. Do not
use acid or alkaline products or solvents
without this indication. Acid or alkaline
maintenance detergents can be used, as
long as they have pH values between four
and ten , and do not contain oxidizing
agents, chlorine or bromine, formaldehyde,
mineral solvents.
ATTENTION: protective gloves should
always be worn before handling detergents
or acidic or alkaline solutions, to avoid
serious injury to the hands.
ATTENTION: always use low-foam
detergent. To avoid the production of foam,
put a minimum quantity of antifoam liquid
in the recovery tank before starting to clean.
Do not use pure acids.
15. Replace the detergent solution fi lling cap
(7) in its seat on the solution tank (Fig.9).
16. Insert the solution tank in the device
(Flg.10).
EN
45