Maintenance - Lavorwash FIT 35B Instrucciones Para El Uso

At the end of the work, and before carrying out any type of maintenance, perform the following
operations:
1. Deactivate the appliance using the main switch (1) (Fig.1 ).
2. Rotate the handlebar so it is vertical.
ATTENTION: during this operation, do not rest your foot on the appliance.
3. Take the device to the dedicated maintenance area.
ATTENTION: The place given over to this operation must comply with current environmental
protection regulations.
4. Remove the power battery (2) from the appliance. To free the battery, shift the stop lever (3) in
the direction of the arrow (Fig.2).
5. Remove the battery from the appliance using the handle mounded on it (Fig.3).
6. Rotate the front cover (4) as far as it will go - do this with the aid of the handle (5) (Fig.4).
ATTENTION: these operations must be carried out using protective gloves to avoid any
possible contact with the edges or tips of metal objects
7. Remove the tunnel cover (6) and shift the stop levers (7) as indicated by the arrows (Fig.5)
8. Remove the brush (8) from the appliance (Fig.6).
ATTENTION: during this process, keep the control handlebar still, in order to prevent the
appliance from moving accidentally.
9. Clean the brush under running water to remove any impurities present in the bristles. Check
that the bristles are not worn; in the event of excessive wear, replace the brush (the bristles
should be at least 10 mm long).
10. Fit the brush (8) on the pin in the brush motor (the brush can only be inserted in one direction)
(Fig.7).
11. Replace the tunnel cover (6) and shift the stop levers (7) as indicated by the arrows (Fig.8).
52

22 MAINTENANCE

EN