Preparing To Work - Lavorwash FIT 35B Instrucciones Para El Uso

19 PREPARING TO WORK

ATTENTION: before beginning the first
work cycle , fully recharge the battery
1. Before using the appliance, make sure it
is in a good , safe working condition. If
everything is not in order, the appliance
must not be used.
2. Rotate the handlebar so it is vertical.
3. Activate the appliance using the main
switch (1) (Fig.1).
ATTENTION: if the LED of the main switch
(1) (Fig.1) is lit up,this means the electrical
system of the appliance is activated.
4. Check the battery charge level. There are
four LEDs (2) on the battery to show the
charge percentage (Fig.2). If all the LEDs are
lit up, the battery is fully charged; if they are
all switched off ,the battery is completely
run down.
5. Deactivate the appliance using the main
switch (1) (Fig.3).
6. Remove the power battery (3) from the
appliance. To free the battery, shift the stop
lever (4) in the direction of the arrow (Fig.4).
7. Remove the battery from the appliance
using the handle mounded on it (Fig.5).
8. Make sure the condition of the squeegee
rubbers is suitable for the work you want to
carry out . If it isn't , perform the necessary
maintenance (read "MAINTENANCE").
9. Make sure the condition of the brush is
suitable for the work you want to carry
out . If it isn't , perform the necessary
maintenance(read " MAINTENANCE").
10. Rotate the front carter (5) as far as it will go ,
do this with the aid of the handle (6) (Fig.6).
11. Remove the solution tank from the device
(Fig.7). Carefully place it on the floor.
12. Remove the detergent solution filling cap
(7) from its seat on the solution tank (Fig.8).
44
EN