Work - Lavorwash FIT 35B Instrucciones Para El Uso

20 WORK

Before beginning to work, it is necessary to:
1. Carry out the operations described in the
"PREPARING TO WORK" chapter.
2. Make sure that the body of the fl oor scrubber
is in contact with the surface to be cleaned,
and not locked. Should this not be the case,
set the machine in vertical position, press
with your thumb as shown in the fi gure,
pull out the knob (1) until the fl oor scrubber
body is released (Fig. 1). Do not pull out
the knob completely to prevent the fl oor
scrubber body from falling forwards, see
"Maintenance".
3. Release the handlebar from its vertical
position and rotate it towards you .
4. Adjust the control handlebar.
5. Activate the appliance using the main
switch (2) (Fig.2).
ATTENTION: if the LED of the main switch
(2) (Fig.2) is lit up, this means the electrical
system of the appliance is activated.
ATTENTION: as soon as the device has
been activated, the front LEDs will light up
and both the brush motor and the vacuum
motor will start working.
6. Activate the detergent solution supply by
pressing the electric pump control switch
(3) (Fig.3).
ATTENTION: if the LED of the electric pump
control switch (3) (Fig.3) is active, this means
the pump will supply detergent solution.
7. The appliance will now begin to work with
full effi ciency until the battery is our of
power or until the detergent solution runs
out.
EN
1
1
47