Lavorwash FIT 35B Instrucciones Para El Uso página 55

ATTENTION: be careful not to lose or damage the seal (20) above the vacuum nozzle
(Fig.29).
33. Use a damp cloth to thoroughly clean the vacuum chamber of the squeegee (21) (Fig.30).
34. Use a damp cloth to thoroughly clean the front rubber of the squeegee (22) (Fig.31). Check the
condition of the front rubber blade; if the edge that is in contact with the fl oor is worn, replace
it.
35. Use a damp cloth to thoroughly clean the rear rubber of the squeegee (23) (Fig.32). Check the
condition of the rear rubber blade; if the edge that is in contact with the fl oor is worn, replace it.
Careful maintenance of the squeegee rubbers guarantees better cleaning and drying of the fl oor, as
well as a longer vacuum motor
life. To replace the squeegee rubbers, proceed as follows:
• Tum the wing nuts (24) that hold the squeegee by 90° (Fig.33).
• Remove the squeegee from the slots on the squeegee connector, taking care not to lose the seal
on the vacuum nozzle (Fig.34).
• Replace the worn/damaged rubber.
• Repeat the operations in reverse order to reassemble all the parts.
36. Bring the squeegee coupling to the idle position and shift the squeegee towards the appliance
(Fig.35).
37. Press the small wheel with your thumb as shown in the fi gure, press knob (18) towards the
equipment (Fig. 36) in order to secure the fl oor scrubber joint in rest position.
ATTENTION: carry out this operation for both the left-hand knob and the right-hand knob.
EN
55