Positioning The Machine In The Durable Storage And Shipping Case; Transport And Assembly - Orbitalum PS 4.5 Plus Traducción Del Manual De Instrucciones Original

PS 4.5 PLUS
7.1

Positioning the machine in the durable storage and shipping case

For a safe transport, the PS 4.5 Plus should be positioned in the durable storage and shipping case as shown in the two pictures
below:
1. Turn the motor 90° on its own axis in the direction of the locking handle (see chap. 9.3, p. 60).
2. The vice (with or without quick mounting plate) should lie parallel to the length side of the case in the wooden enclosure.
3. The slide housing with motor then should be rotated approx. 70° sidewards, so that it fits into the case enclosure.
PS with quick mounting plate
8.

TRANSPORT AND ASSeMBLY

WARNING!
WARNING!
[REV. 20200320] OC_PS_BA_790048761_00__INH-02_EN
70°
PS without quick mounting plate
When switching the motor on, the machine may revolve around the tube
automatically!
Diverse physical injuries and material damage.
X In their home position, the saw blade must not touch the tube.
X Make sure that the slide housing is in the home position when the cutting process starts.
X Clamp the tube to be cut into the vice.
X Before switching the motor on, make sure that the gap between the saw blade and the
tube is sufficient, and that the tube is securely clamped in the vice.
X Place sufficient tube supports under the tube.
Flying parts/breaking tool!
Diverse physical injuries and material damage.
X Do not process the tube while it is loose in the vice.
X Never use a damaged or deformed saw blade.
X In the event of tool breakage with a new tool, do not enter the old cut because the tool
can break again.
X Clamp the tube to be cut into the vice.
X Immediately replace worn-out tools.
X Ensure that the cutting tools are correctly fitted.
X Tube dimension must be set correctly. During cutting, the saw blade must saw through
the entire tube wall.
X Avoid breaking tool through low (adequate) feed force, correct dimension (see chap. 8.7,
p. 55) and speed (see chap. 8.8, p. 56) settings.
X Hold on to the motor unit tightly by the handle, and guide it with low (adequate) feed
force during the machining process.
Transport and assembly
70°
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
47