Mounting The Saw Blade On Saw Position 2 - Orbitalum PS 4.5 Plus Traducción Del Manual De Instrucciones Original

PS 4.5 PLUS
6. Mount the saw blade on the shaft (9) with the inscription pointing to the fixed clamping plate.
7. Place the saw blade nut onto the shaft again and tighten slightly using a fork ring wrench a/f 2 (anti-clockwise thread).
5
8.6

Mounting the saw blade on saw position 2

WARNING!
WARNING!
[REV. 20200320] OC_PS_BA_790048761_00__INH-02_EN
Flying, hot and sharp-edged chips, tube surfaces, cutting edges and tools!
Danger of injury to eyes and hands.
X Do not reach into the rotating tool during working.
X Never work without the saw chip guard mounted.
X Wear recommended protective clothing, as described in chap. 2.4, p. 38.
X Before transportation or changing the workplace, switch off the machine, wait until the ma-
chine/tool stops running and pull the mains plug. Remove chips with tightfitting safety gloves
(in accordance with DIN EN 388 and EN 407) using suitable tools (e.g. tongs or screwdriver).
X Make sure the chips guard is working.
When switching the motor on, the machine may revolve around the tube
automatically!
Diverse physical injuries and material damage.
X In their home position, the saw blade must not touch the tube.
X Make sure that the slide housing is in the home position when the cutting process starts.
X Clamp the tube to be cut into the vice.
X Before switching the motor on, make sure that the gap between the saw blade and the
tube is sufficient, and that the tube is securely clamped in the vice.
X Place sufficient tube supports under the tube.
Transport and assembly
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
9
53