Clamping The Tube And Adjusting The Tube Dimension - Orbitalum PS 4.5 Plus Traducción Del Manual De Instrucciones Original

PS 4.5 PLUS
5. Mount the saw blade on the saw blade shaft.
6. Tighten the clamping screw clockwise slightly using a hexagon key wrench.
8.7

clamping the tube and adjusting the tube dimension

WARNING!
1. Use the hand wheel (2) to turn the slide (1) with saw blade down to the lowest position (to the largest tube dimension).
2. Move the tube (3) towards the saw blade (4) until it is just in front of the blade; clamp the tube by means of the turning
handle (5).
5 1
[REV. 20200320] OC_PS_BA_790048761_00__INH-02_EN
When switching the motor on, the machine may revolve around the tube
automatically!
Diverse physical injuries and material damage.
X In their home position, the saw blade must not touch the tube.
X Make sure that the slide housing is in the home position when the cutting process starts.
X Clamp the tube to be cut into the vice.
X Before switching the motor on, make sure that the gap between the saw blade and the
tube is sufficient, and that the tube is securely clamped in the vice.
X Place sufficient tube supports under the tube.
2
Transport and assembly
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
3
4
55