Mounting The Saw Blade On Saw Position 1 - Orbitalum PS 4.5 Plus Traducción Del Manual De Instrucciones Original

PS 4.5 PLUS
8.5

Mounting the saw blade on saw position 1

WARNING!
WARNING!
WARNING!
NOTe!
[REV. 20200320] OC_PS_BA_790048761_00__INH-02_EN
Flying, hot and sharp-edged chips, tube surfaces, cutting edges and tools!
Danger of injury to eyes and hands.
X Do not reach into the rotating tool during working.
X Never work without the saw chip guard mounted.
X Wear recommended protective clothing, as described in chap. 2.4, p. 38.
X Before transportation or changing the workplace, switch off the machine, wait until the
machine/tool stops running and pull the mains plug. Remove chips with tightfitting
safety gloves (in accordance with DIN EN 388 and EN 407) using suitable tools (e.g.
tongs or screwdriver).
X Make sure the chips guard is working.
When switching the motor on, the machine may revolve around the tube
automatically!
Diverse physical injuries and material damage.
X In their home position, the saw blade must not touch the tube.
X Make sure that the slide housing is in the home position when the cutting process starts.
X Clamp the tube to be cut into the vice.
X Before switching the motor on, make sure that the gap between the saw blade and the
tube is sufficient, and that the tube is securely clamped in the vice.
X Place sufficient tube supports under the tube.
Flying parts/breaking tool!
Diverse physical injuries and material damage.
X Do not process the tube while it is loose in the vice.
X Never use a damaged or deformed saw blade.
X In the event of tool breakage with a new tool, do not enter the old cut because the tool
can break again.
X Clamp the tube to be cut into the vice.
X Immediately replace worn-out tools.
X Ensure that the cutting tools are correctly fitted.
X Tube dimension must be set correctly. During cutting, the saw blade must saw through
the entire tube wall.
X Avoid breaking tool through low (adequate) feed force, correct dimension (see chap. 8.7,
p. 55) and speed (see chap. 8.8, p. 56) settings.
X Hold on to the motor unit tightly by the handle, and guide it with low (adequate) feed
force during the machining process.
It is only possible to mount or replace the saw blades if no tube has been clamped into the vice
before. If necessary, remove the tube before mounting the saw blade (see chap. 8.7, p. 55).
Transport and assembly
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
51