Operation - Orbitalum PS 4.5 Plus Traducción Del Manual De Instrucciones Original

PS 4.5 PLUS
9.

OPeRATION

DANGeR!
DANGeR!
DANGeR!
DANGeR!
WARNING!
WARNING!
WARNING!
WARNING!
[REV. 20200320] OC_PS_BA_790048761_00__INH-02_EN
Machine start-up due to unintentional pressing of the ON/OFF switch or the
speed regulator!
Fatal electric shock.
Diverse physical injuries and material damage.
X Prior to assembly, dismantling, maintenance and adjustment work, disconnect the
machine from the mains supply and allow it to run to a stop.
When the slide housing is rotating, excess lubricant can get into the motor unit!
Fatal electric shock.
X Remove excess lubricant from the machine after every step.
X Apply only a minium of lubricant to the saw blade so that no residues can get into the
motor unit.
Unexpected start­up!
Serious injury or death.
X Before connecting the machine to the power supply, check the on/off switch is switched off.
Loose/baggy clothing, long hair or jewelry can get caught in rotating
machine parts!
Serious injury or death.
X Wear tight-fitting clothing when using the machine.
X Tie up long hair to prevent it from being caught.
Flying parts/breaking tool!
Diverse physical injuries and material damage.
X Do not process the tube while it is loose in the vice.
X Never use a damaged or deformed saw blade.
X In the event of tool breakage with a new tool, do not enter the old cut because the tool
can break again.
X Clamp the tube to be cut into the vice.
X Immediately replace worn-out tools.
X Ensure that the cutting tools are correctly fitted.
X Tube dimension must be set correctly. During cutting, the saw blade must saw through
the entire tube wall.
X Avoid breaking tool through low (adequate) feed force, correct dimension (see chap. 8.7,
p. 55) and speed (see chap. 8.8, p. 56) settings.
X Hold on to the motor unit tightly by the handle, and guide it with low (adequate) feed
force during the machining process.
Risk of machine and tube falling!
Irreversible crushing.
X Check the machine's position and secure it so it cannot fall.
X Place sufficient tube supports under the tube.
Trapped fingers between the vice/clamping shell and tube!
Irreversible crushing.
X Do not insert fingers between the vice/clamping shell and tube.
Body parts can fit between the cutting tools and the tube!
Serious injury.
X Do not place body parts between the cutting tools and the tube.
Operation
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
57