Orbitalum PS 4.5 Plus Traducción Del Manual De Instrucciones Original página 59

PS 4.5 PLUS
1. Fasten the saw blade.
2. Set pipe dimension and penetration depth (see chap. 8.7, p. 55).
3. Mark the point of separation on the tube.
4. Move the tube forward in the vice until reaching the desired tube length and clamp it (see chap. 8.7, p. 55). Pay attention to
clean clamping surfaces.
IMPORTANT!
5. Connect the PS to power supply.
6. Switch the motor on by pressing the ON/OFF switch (1) and keep the switch pressed; lock it by means of the arrest button (2).
1
7. Select the speed stage (see chap. 8.8, p. 56).
8. Slowly turn the PS clockwise holding it at the grip until the tube wall is pierced.
9. Go on turning smoothly until the tube is cut off.
10. Turn the tube saw back counterclockwise to its original position.
11. Switch the motor off pressing the ON/OFF switch.
[REV. 20200320] OC_PS_BA_790048761_00__INH-02_EN
• Apply saw blade lubricant to the saw blade after each cut.
• Use only saw blade lubricant (no oils) from Orbitalum Tools
(e.g. GF LUB or GF TOP).
• Keep the machine clean. Always remove residue from lubricant
from the machine.
• The clamping area of the clamping jaws must be free of dirt,
chips and lubricants.
2
Operation
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
59