Orbitalum PS 4.5 Plus Traducción Del Manual De Instrucciones Original página 52

eNGLISH
Transport and assembly
1. For a better access to the saw blade, open the clamping jaws (3) by turning the turning handle (4) counterclockwise to the
limit stop.
2. Move the slide (5) upwards by turning the hand wheel (6) clockwise to the limit stop.
4
3. Loosen the saw blade nut (7) using the ring spanner SW 22 (Attention: left-handed thread!).
4. Remove the saw blade nut and the saw blade from the shaft.
5. Clean the saw blade shaft, the contact surface of the clamp and the surrounding using a brush.
NOTe!
7
ATTeNTION!
52
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
3
The clamping plate (8) must not be removed.
Damage to material!
X The saw blade must be free from chips and dirt.
X Only use Orbitalum Tools saw blades.
X Mount the saw blade on the shaft with the inscription pointing to the slide (5). The teeth
are now arranged in the correct direction.
5
[REV. 20200320] OC_PS_BA_790048761_00__INH-02_EN
PS 4.5 PLUS
6
8