10. Servicing, Maintenance, Troubleshooting; Maintenance; Laser - Orbitalum PS 4.5 Plus Traducción Del Manual De Instrucciones Original

PS 4.5 PLUS

10. SERVICING, MAINTENANCE, TROUBLESHOOTING

NOTe!
DANGeR!
DANGeR!
10.1

Maintenance

TIME/INTERVAL
Before starting work
Daily
Every time the tube saw is cleaned.
10.1.1

Laser

X No maintenance for the laser required.
X For the Laser is no service allowed.
X The laser has to be returned to the factory for any service or repair.
X It is not allowed to open, modify or to remove protective covers or housings except for battery change.
[REV. 20200320] OC_PS_BA_790048761_00__INH-02_EN
Servicing, maintenance, troubleshooting
Some of the work mentioned depends a great deal on the use and on the ambient conditions.
The cycles specified are minimum specifications. In individual cases, differing maintenance
cycles are possible. To ensure the safety of the machine, perform maintenance annually
using an authorized service center with VDE testing. If the machine does not function as
previously described, the machine must also be sent into an authorized service center.
Danger of death by electric shock!
Non-observance could result in death or serious injury.
X At the end of each working cycle, before transportation, changing tools, cleaning and
performing any maintenance, adjustment or repair work, switch off the machine, wait
until the machine/tool stops running and pull the mains plug.
Risk of electric shock due to poor electrics!
Fatal electric shock.
X At the end of each working cycle, before transportation, changing tools, cleaning and
performing any maintenance, adjustment or repair work, switch off the machine, wait
until the machine/tool stops running and pull the mains plug.
X Repair and maintenance work on the electrical equipment may only be carried out by a
qualified electrician.
AcTIVITY
X Remove any chips and dirt from the saw blades.
X Remove any chips and dirt from the guiding blade and the threaded spindle of the vice.
X Remove the saw blade and use the brush to brush off any chips.
X Clean the shafts using a cloth or brush.
X Use a brush to remove any chips from between the slide and the slide housing. To do
so, move the slide to the upper and lower position.
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
eNGLISH
61