Mounting The Machine On The Work Bench; Mounting The Machine On The Work Bench Without Quick Mounting Plate; Mounting The Machine On The Work Bench With Quick Mounting Plate - Orbitalum PS 4.5 Plus Traducción Del Manual De Instrucciones Original

eNGLISH
Transport and assembly
8.1

Mounting the machine on the work bench

NOTe!
Mount the machine together with the vice, either:
• without quick mounting plate on the work bench (see chap. 8.1.1, p. 48), or
• with quick mounting plate on the work bench (see chap. 8.1.2, p. 48), or
• directly on the Tripod (see chap. 8.1.3, p. 49).
8.1.1 Mounting the machine on the
work bench without quick
mounting plate
1. Use the PS as a template to punch holes in the work
bench.
2. Drill 4 holes of 9 mm Ø.
3. Fasten the PS to the work bench using 4 included hexa-
gon socket screws with nuts (1).
8.1.2 Mounting the machine on the
work bench with quick mount­
ing plate
The quick mounting plate with screw clamps is not included in
the scope of supply but is obtainable as accessory (see chap.
3.2, p. 43).
1. Screw the quick mounting plate to the work bench by
means of the 2 screw clamps.
2. Mount the PS to the quick mounting plate with 4 included
Allen screws.
48
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
Prior to initial operation of the portable tube cutter, the electric motor must be rotated 90°
anticlockwise so that the handle of the motor points toward the front (see chap. 7.1, p. 47).
PS 4.5 PLUS
1
1
[REV. 20200320] OC_PS_BA_790048761_00__INH-02_EN