Preparation For Use - Royal Catering RCPS-16BE Manual De Instrucciones

a) Melting temperature setting dial
b) Handle
c) Power connection socket
d) Connection to supply hose (not visible in the picture)
3.2.

Preparation for use

POSITIONING OF THE UNIT
The ambient temperature must not exceed 40°C and ambient humidity should not
exceed 85%. Place the appliance in a way that ensures good air circulation.
Maintain a minimum clearance of 10 cm from any wall of the unit. Keep the
appliance away from any hot surfaces. Always operate the device on a level,
stable, clean, fireproof and dry surface and out of the reach of children and
persons of impaired mental, sensory and intellectual functions. Place the appliance
in such a way that the mains plug can be reached at any time. Ensure that the
power supply to the appliance corresponds to that specified on the identification
plate!
Before the first use, disassemble the pot and wash its interior (Teflon layer) as well
as the plate on which the popcorn will be placed. Clean all the popcorn accessories
as well.
ASSEMBLY OF THE UNIT
Using the screws provided, fix the transparent door wings and their handles. Set
the unit in its final location and connect it to the appropriate electrical system (see
the parameters table and/or rating plate) and external ventilation.
NOTE: Only a qualified electrician should connect the RCPS-32BE to the electrical
connection.
The yellow-green wire is designated to connect the protective conductor.
The three phases (black, brown, blue) can freely be connected to L1, L2 and L3.
After connecting to the power supply, briefly switch on the display cabinet's
backlight by pressing the switch (8) on the control panel inside the display cabinet.
If the light bulb illuminates after the switch is pressed, the unit is connected
correctly to the power supply.
Switch off the display cabinet backlight. Then place a container with oil in the
lower part of the unit - the cabinet - and install the pumping unit on it and connect
it to the corresponding plug.
Tighten the plug in the socket to secure the connection.
Then connect the liquid fat hose to the back of the pump unit, i.e. insert it into the