Mounting The Hood - arietta ASG436SSB Guía De Instrucciones Para Instalación

Wall Installation
Install framing for hood support
1.
Mark the screw hole locations indicated in the "Outside rear
exhaust" figure.
2.
If drywall is present, cut away enough drywall to expose
2 vertical studs at the indicated holes location. Install two
horizontal supports between two wall studs at the bottom and
upper mounting holes installation location.
3. The horizontal support must be flush with the room side of the
studs. Use cleats behind both sides of the support to secure
wall studs.
4. Reinstall drywall and refinish.
IMPORTANT: Framing must be capable of
Centerline of
Installation
Space
5. Cut holes at marked locations for duct and electrical wiring.

Mounting the Hood

1.
Drive a mounting screw (from the hardware package) partway
into each center of the narrow neck of the keyhole slots
marked on the cabinet bottom or the wall's support frame.
2. Install the 2 pieces of the selected screws on the mountings
screws location (see the image). Leave a
between the wall and the back of the screw head to slide
range hood into place.
⁄ "
1
4
(6.4 mm)
3.
Fix the wiring conduit of the hood.
4. Slide the hood back against the wall. Tighten the mounting
screws. Be sure the screw heads are in the narrow neck of the
keyhole slot.
supporting 100 lbs.
View from rear
Cleats
Mounting
Support
⁄ " (6.4 mm) gap
1
4
B
C
A. Mounting screws
B. Upper security screws (Wall Installation)
C. Lower security screws (Wall Installation)
5. Drive 2 pieces of the selected screws in the upper security
screws location (see the image above).
6.
Drive 2 pieces of the selected screws in the lower security
screws location (see the image above).
7. Drive 2 pieces of the selected screws in the lower security
screws location (see the image below).
8. Connect Ductwork to hood.
7
A
B