Devolo Giga Bridge Manual página 67

G.hn Flashing behav-
LED iour
5 White Lights up steady
LED
6 White Flashes at inter-
LED vals of
on/ 3 sec off
7 Red and Flashes at inter-
white vals of
LED on/2 sec. off
8 Red and Flashes at inter-
white vals of
LED red/0.5 sec.
white
* Information about the web interface can be
found in Chapter 4 Configuration.
**Depending on the configuration, a Giga Bridge
adapter switches to standby mode after approxi-
mately 10 minutes if no active network device (e.g.
computer) is connected to the network interface.
As soon as the network device (e.g. computer) con-
nected to the network interface is switched on
Meaning
The connection does not have any issues
and the Giga Bridge adapters are ready
to operate.
The Giga Bridge adapter is in standby
0.1 sec. mode.**
The data transmission rate is not in the
0.1 sec. optimal range (PHY rate below 1 Gbps)
The Giga Bridge adapter is carrying out
0.5 sec. a firmware update.
again, your Giga Bridge adapter can also be ac-
cessed again.
LED status display
(web interface*)
Can be disabled
Can be disabled
Cannot be disabled
Cannot be disabled
Check whether the adapter is connected to
the mains supply correctly and whether the
pairing operation has been carried out suc-
cessfully. For more information about this,
refer to 3.3 Pairing – Establishing a G.hn
connection.
devolo Giga Bridge
Introduction 18