Pairing - Establishing A G.hn Connection; Automatic Pairing - Devolo Giga Bridge Manual

21 Initial use
CAUTION! Damage to the device caused
by ambient conditions
Only use device indoors in dry conditions
DANGER! Electric shock caused by elec-
tricity
Device must be plugged into a power sock-
et with a connected earth wire (PE)
CAUTION! Damage to the device caused
by unpermitted voltage rangeg
Only operate devices on mains power sup-
ply as described on the rating plate.
Technical data
For the permitted voltage range for operat-
ing the device and the power consumption,
refer to the type plate on the rear of the de-
vice.
For further technical data of this product,
please refer to the data sheet in the down-
load area of the respective product page on
the Internet at www.devolo.global.
CAUTION! Damage to telephone, DSL
and/or TV services when connected to
non-cleared lines
Only use the device on cleared—exclusively
available—telephone or coaxial cables
devolo Giga Bridge
Note: Free line availability without third-party
devices must be determined before connecting
the devolo Giga Bridge.
No liability is assumed for any damage to third-
party devices.
3.3 Pairing – Establishing a G.hn
connection
CAUTION! Tripping hazard
Lay the cable in a barrier-free manner and
ensure that the electrical socket and the
connected network devices are easily ac-
cessible

3.3.1 Automatic pairing

To set up a Giga Bridge network, you need at least
two Giga Bridge adapters. Giga Bridge adapters
that are in factory default condition (i.e. have been
recently purchased or successfully reset) automat-
ically attempt to pair with each other. To do this,
the adapters must be connected both to the
mains and directly to each other by cable (net-
work cable to the G.hn phone line socket or coax
cable to the coaxial socket.)