Control - SPORTSTECH VP500 Manual De Usuario

6. Control

You can control the vibration plate via the console on the device and/or via
the remote control (see below).
WARNING! Risk of tipping over and falling!
Do not use the buttons on the vibration plate while standing
•
on the device.
Remote control Console
Console
Description
Power: Press to switch device on or off when power cable is connected.
Program stop: Stop a currently running program.
Program start: Start or restart a new or a paused program.
Program selector: Press to switch between manual mode, P1, P2 or P3.
The currently selected mode/ program is shown on the lower middle of
the display.
Auto mode: - Single click: Activate automatic...
- Press several times: Switch between programs P1, P2, P3.
In automatic mode, only the selection of programs is possible. The speed
and time are not adjustable in this mode.
Speed+/- : In manual mode....
press Speed + to increase the speed in steps of 1-60
press Speed- to decrease the speed in steps of 1-60.
Manual mode
In standby, press 'MANUAL MODE' several times on the remote control:
1 Click =
4 Click =
+
7 Click =
+ +
Description
Activity indicator:
Vertical / horizontal oscillation / vibration
For current training:
Display duration, level and calories (estimated value)
Vertical lines: Level indicator; corresponds to the frequencies (see 5.2)
Small dots with 'Px': Shows the currently selected program.
2 Click = 3 Click =
5 Click = 6 Click =
+
EN DE
+
27