Pit Boss PRO Serie Montaje Y Operación página 8

2. INSTALLING THE BOTTOM SHELF
Parts Required:
1 x Bottom Shelf (#23)
4 x Screw (#A)
4 x Washer (#B)
4 x Locking Washer (#C)
Installation:
• Mount the Bottom Shelf to each Support Leg using a screw, locking
washer, and washer. Ensure the flat surface of the shelf is facing up
towards the Grill Barrel.
3. ADDING WHEELS TO THE CART
Parts Required:
2 x Foot Gasket - A (#24)
2 x Foot Gasket - B (#25)
4 x Locking Caster Wheels (#26)
12 x Screw (#A)
12 x Washer (#B)
12 x Locking Washer (#C)
Installation:
• Place Foot Gasket between the Support Leg and Locking Caster Wheel.
Hand-tightening three screws, locking washers, and washers into the
holes on each Support Leg. Ensure that each Locking Caster Wheel is
inserted completely. Note illustration.
• Once the shelf is secure, carefully lift the grill into an upright position.
IMPORTANT: Re-tighten the support leg screws to ensure they are
completely secure after positioning the grill upright.
4. INSTALLING THE LID HANDLE
Parts Required:
1 x Lid Handle (#7)
Installation:
• Remove the pre-installed screws from the Lid Handle. From inside the
barrel lid, insert one screw to protrude to the outside, then hand tighten
the screw (from the inside) into the Lid Handle.
• Repeat the same installation for the other end of Lid Handle.
8
2
A
C
B A
C
B
23
B
B
C
C
A
A
3
24
26
25
26
25
26
24
26
4
7