M M o o t t o o r r O O v v e e r r l l o o a a d d C C u u r r r r e e n n t t : : Set the exact current rating of the motor, which will override the DIP switch

presets (surface applications).

M M i i n n i i m m u u m m a a n n d d M M a a x x i i m m u u m m O O u u t t p p u u t t F F r r e e q q u u e e n n c c y y : : Set an exact frequency range for more precise control

than the DIP switch presets.

P P r r e e s s s s u u r r e e C C o o n n t t r r o o l l

S S e e n n s s o o r r T T y y p p e e : : This parameter sets which type of pressure sensor is being used.

•

Switch – Use when connecting to a standard pressure sensor.

•

Transducer (PSI) – Use for a 4-20mA pressure transducer scaled to psi.

•

Transducer (bar) – Use for a 4-20mA pressure transducer scaled to bar.

T T r r a a n n s s d d u u c c e e r r R R a a n n g g e e : : Sets the range of the transducer connected to the drive, when using a pressure

transducer.

•

100 to 300 psi

•

Default = 100 psi

P P r r i i m m a a r r y y S S e e t t p p o o i i n n t t : : Sets the target pressure the drive will maintain, when using a pressure transducer.

•

5 psi to T T r r a a n n s s d d u u c c e e r r R R a a n n g g e e — 5

•

Default = 50 psi

D D r r a a w w d d o o w w n n : : Allows the drive to regulate to the Pressure Setpoint and remain off until pressure drops to

the C C u u t t I I n n S S e e t t p p o o i i n n t t .

•

Disabled/Enabled

C C u u t t I I n n S S e e t t p p o o i i n n t t : : Sets the low pressure limit before the drive restarts, when using the Drawdown

function.

•

5 psi to P P r r i i m m a a r r y y S S e e t t p p o o i i n n t t —1

•

Default = 40 psi

P P r r o o p p o o r r t t i i o o n n a a l l G G a a i i n n : : Determines transducer input sensitivity. A greater value provides more sensitivity.

However, if set too high, the system may create an output frequency oscillation.

I I n n t t e e g g r r a a t t i i o o n n T T i i m m e e : : Determines response time to transducer input. A greater value provides slower re-

sponse and may cause oscillation of output frequency.

COMMUNICATIONS

FE Connect Mobile Application

"Drive Con-