Publicidad
Idiomas disponibles
Idiomas disponibles
Hitching and unhitching the work vehicle to and from the tractor
Danger - Warning
Hitching the work vehicle up to the tractor is one of the riskiest moments as it could required the involvement
of several people at once, carrying out synchronised manoeuvres between the tractor driver and the operators
on the ground, which - if badly organised - could result in accidents.
The work vehicle must only ever be coupled to a tractor with an appropriate power rating which is equipped
with a lift that complies with the regulations in force, observing the maximum weight limit on the rear axle
and the gross vehicle weight (see tractor user manual).
Check that the work vehicle coupling to the tractor at the third point of the hitch is securely locked so that it
cannot work loose.
A
UN41 0185MG
For hitching, proceed as outlined below.
1)
Position the work vehicle on flat, solid ground in a
risk-free area.
2)
Start moving the tractor to move the three-point
hitch up to the lift frame.
3)
Align the arms of the lifting unit with the coupling
points on the work vehicle.
4)
Switch off the tractor engine, remove the ignition
key and store in a safe place.
5)
Turn the tie rods (A) to adjust the height of the lift
arms (B) (see tractor instruction manual).
6)
Insert the pins (C) into the lift arms and fit in the lock
pins (D).
7)
Turn the tie-rod (E) to adjust the space between the
tie-rod and the upper coupling (F) of the support
frame.
8)
Insert the pin (G) and the lock pin (H).
English language
INFORMATION FOR USE
E
A
G
H
F
C
9)
Remove lock pin (L), slide out the pin (M) and lift the
resting foot (N) off the ground.
10) Adjust the tie-rod (E) so that the work vehicle is par-
allel with the ground.
For unhitching, proceed as outlined below.
1)
Select an area with flat, solid ground to park the
work vehicle - tractor.
2)
Using the tractor's controls, lower the work vehicle
to the ground.
3)
Lower the resting foot (N) on the ground, insert the
pin (M) and the lock pin (L).
4)
Switch off the tractor engine, remove the ignition
key and store in a safe place.
5)
Take out the lock pin (H) and remove the pin (G).
6)
Slide out the lock pins (D) and remove the lift arms
(B) from the work vehicle's coupling points.
26
D
M
B
Use and maintenance
6
L
N
Publicidad
