Publicidad
Idiomas disponibles
Idiomas disponibles
12.6
-1°
Fig. 12.6
When aligning the headset cup, the etching that is at the front of the bike indicates which
setting you are in.
Make sure the head tube and headset cup are free of dirt and debris when
changing the upper cup angle. Lubricate all the parts with high-quality
waterproof grease.
All models are assembled with the zero offset headset cup. Switching the
headset cup steepens or slackens the head tube angle by +/-1 degree.
The bottom headset cup is used for all options of adjustability. The cup has
a spherical interface with the headtube and will move with the angle of the
steerer tube.
12.7
+1°
Fig. 12.7
Slide the fork steerer tube back through the headtube and headset parts (A).
„
Install the stem onto the steerer tube (B).
„
Install the top cap and compression bolt into the star nut in the fork (C). Tighten the bolt
„
until all the parts are snug and settled. The stem should rotate freely, but there should be no
fore/aft free play in the system.
Pull front brake and rock the bike back-and-forth a few times with the stem bolts loosened
„
to make sure everything is well seated.
If necessary re-tighten the headset top cap (C).
„
Torque the stem bolts to the recommended torque setting (D).
„
C
D
B
D
A
38
Publicidad
