Casselin CPSTCF25 Manual De Instrucciones página 32

FACILITY
USER REQUIREMENTS
The environmental conditions of the place where the machine is installed must have
the following characteristics:
-
be dry
-
sufficiently different water sources of heat adequate ventilation and lighting
-
complying with the health and safety standards provided for by the legislation
in force.
-
The support surface must be horizontal, obstacles of any kind must not be
placed in the immediate vicinity of the machine which could affect its normal
ventilation.
IMPORTANT
In accordance with the legislation in force, the electrical network must be equipped with a differential circuit
breaker with characteristics suitable for those of the machine in which the opening distance of the contacts is at
least 3 mm; essential, moreover, an effective earthing system.
Check that the power supply voltage and the frequency of the installation are compatible with the values indicated
both in thetechnical characteristicsand on the plate located at the rear of the machine.
INSTALLATION MODALITIES
IMPORTANT
All installation and maintenance operations must be carried out by qualified personnel authorized by the
manufacturer, who declines all responsibility arising from incorrect installation or any handling.
The machine is delivered on a pallet in closed packaging with cardboard. For handling, you need a forklift or a pallet
truck. If the machine is lifted using ropes or straps, pass these under the pallet.
To remove the machine from the packaging, you can use the straps located under the machine and attached to
a forklift (FIG.3).
NOTICED
All parts related to the packaging must be disposed of in accordance with current legislation.
After removing the packaging from the machine, proceed as follows:
- Place the machine in the desired position.
-
Remove the protective film, if present, avoiding the use of tools that may damage the surfaces.
-
If the machine is fitted with wheels, make sure they are locked with the brake by pushing lever "A"
down until it locks (FIG.4).
-
If the machine is unstable, place hard rubber parts under the wheels.
5