Kulzer Translux 2Wave Instrucciones De Uso página 49

carried out by Kulzer and/or authorized Kulzer service partners only.
For possible damage coming from a fault/malfunction of the unit due to improper repair, which was not carried out by
Kulzer and/or authorized Kulzer service partners only or in cases where original spare/accessory parts were not used
during a part replacement, Mectron S.p.A. is not liable.
4 Unit description
4.1 Delivery contents
Charging unit
1
Hand piece
2
Light guide, ∅ = 8 mm
3
4 Protective light cone
5 Rechargeable Lithium-ion battery pack
Universal input power supply (100 V – 240 V (
6
6a = Europe type 1
6b = UK
6c = US / JP type 3
NOTE
These components can also be ordered separately.
4.2 Description of the control and operating elements
4.2.1 Hand piece
" STAND-BY " button
1
2 Display
3 " Time / Program " button for selecting the curing program and the exposure times
4 Charging unit contacts
Alignment key
5
4.2.2 Alignment key
The alignment key ( 5 ), located at the back bottom part of the hand piece's case, allows the correct
insertion of the hand piece in the charging unit holder.
When inserting the hand piece into the charging unit, the alignment key must be aligned with the
guiding slot positioned inside the charging unit.
A beep confirms that the contacts are in the correct charging position!
4.2.3 Hand piece display
The information provided by the hand piece display are described here below:
1 Battery status
The battery icon indicates the charging state and eventual anomalies of the battery.
The black bars in the battery icon will light up progressively during the charging phase.
When the battery is fully charged, all four internal bars light up.
NOTE
If the battery is completely empty, the charging operation starts with a " prequalification state " during
which the Translux 2Wave micro-processor checks the functional charging parameters of the battery.
During the prequalification state the first black bar inside the battery icon blinks. If the functional
charging parameters are correct, the regular charging phase starts and all the black bars in the battery
icon will light up progressively.
NOTE – Faulty Battery
In case of a defective battery, the battery icon, with no internal black bars,
will continuously blink.
A " beep " sound is emitted every second for a period of 30 seconds.
After 30 seconds only the battery icon frame remains blinking.
IMPORTANT
This error condition is detected and shown only when the hand piece is placed in the
charging unit.
type 2
)) including international mains socket adapters:
1x
GB
- 9 -
2x
2x
2x
blinking