MSA ALTAIR 5X Manual De Uso página 15

○ Disconnect the charger momentarily to reset the charge cycle.
• The battery pack may be charged separately from the device.
• During periods of non-use, the charger may remain connected to the device/battery pack.
NOTE: The charger must be disconnected for the device to operate.
3.5 Viewing Additional Pages
The Main Screen appears at device turn-ON.
Additional displays can be viewed by pressing the ▼ button to move to the screen as indicated by the "soft key".
(For the monochromatic display the name of the page is displayed. For the color version it is represented by an icon.)
The sequence of pages are as follows and are described in
Advance on
MAIN
BUMP TEST ?
MEASURE
PAGE
Advance on
WUSB **
* IF ENABLED
** IF WUSB IS INSTALLED
Advance on
1
NOT VALID FOR ALL SENSORS
MOTION
ALERT
STATUS *
DISCOVERY
VOC*
MODE*
Figure 6 Sequence of Pages
3.5.1 Bump Test (BUMP page)
This page allows the user to perform an automated Bump Test on the device. To perform the test, the (YES) button is
pressed. See 4.9 Bump Test
If the ▼ button is pressed, the Bump Test is not performed, and the display shows the next page in the sequence (PEAK).
If the ▲ button is pressed, the Bump Test is not performed, and the display reverts back to the normal MEASURE page.
Peak Readings (PEAK page)
Monochromatic Display
PEAK
This page shows the highest levels of gas recorded by the device since turn-ON or since peak readings were reset.
To reset the peak readings:
US
* 1
PEAK * MIN
1
STEL *
1
TWA *
DATE
LAST CAL
CAL DUE
DATE *
DATE *
for details on performing the Bump Test.
Color Display
ALTAIR 5X / ALTAIR 5X IR
Figure 6 :
3 Description
15