Hillrom A-70117 Instrucciones De Uso página 13

INSTRUCTIONS FOR USE
3.2 Setup:
1. Position the patient on the table
2. Completely unscrew the knob in the
traction clamp.
3. Put the traction clamp over the lateral
bar of the C-Flex. The clamp may be put
on either side of C-Flex.
4. Put the traction bar through the top and
bottom holes of the traction clamp. The
traction guide should be positioned
beyond the back of C-Flex.
5. Adjust the traction bar to the
desired height. Make sure to
leave at least 1" (2.54cm) of the
traction bar protruding below the
bottom of the traction clamp.
6. Fully tighten the knob in the
traction clamp.
7. Test that the traction bar is
properly secured.
8. Guide the rope from the weights
through the hole in the traction
guide
Document Number: 80028173
Version C
Make sure OR table is stable after adding traction weight
1"
Page 13
Issue Date: 26 MAR 2020
Ref Blank Template: 80025117 Ver. F