Kärcher B 260 RI Combo Manual De Instrucciones página 11

Accessories and spare parts
Only use original accessories and original spare parts.
They ensure that the appliance will run fault-free and
safely.
Information on accessories and spare parts can be
found at www.kaercher.com.
Scope of delivery
Check the contents for completeness when unpacking.
If any accessories are missing or in the event of any
shipping damage, please notify your dealer.
Safety instructions
Before using the device for the first time, read and ob-
serve these operating instructions and the accompany-
ing brochure: Safety instructions for brush cleaning
devices, No. 5.956-251.0.
The device is approved for operation on surfaces with a
specified limited slope (see chapter "Technical Data").
WARNING
The device can tip over
Risk of injury
Only operate the device on surfaces that do not exceed
the permitted slope (see chapter "Technical Data").
WARNING
Risk of accident due to incorrect operation
People can be injured.
Operators must be properly trained on how to use this
machine.
The device may only be operated when the hood and all
covers are closed.
Safety devices
CAUTION
Missing or modified safety devices!
Safety devices are provided for your own protection.
Do not bypass, remove or render ineffective any safety
devices.
Safety switch
For immediate shutdown of all functions: Set the safety
switch to "0".
● The device brakes hard when the safety switch is
switched off.
● The safety switch acts directly on all device func-
tions
Seat switch
If the operator leaves the seat during work or while driv-
ing, the seat switch switches off the engine after a short
delay.
Warning symbols
Observe the following warnings when handling the bat-
teries:
Observe notes in the instructions for the
battery, on the battery and in these oper-
ating instructions.
Wear eye protection.
Keep acids and battery away from chil-
dren.
Risk of explosion
Fire, sparks, open flames and smoking
are prohibited.
Risk of acid burns
First aid.
Warning
Disposal
Do not dispose of used batteries in the
residual waste.
DANGER
Danger due to explosion
Risk of injury and damage
Do not place any tools or objects on the battery, i.e. on
the end poles and cell connectors.
DANGER
Risk of injury!
Ensure that wounds never come into contact with lead.
Always clean your hands after working on batteries.
Symbols on the charger
DANGER
Risk of fire
If plugged into an unsuitable socket or in the event of
poor electrical connection between the plug and the
socket, the charger plug and the socket used may get
very hot.
Before plugging in the mains plug, make sure that the
socket is approved for a current of 16 A and that it is in
a technically sound condition.
Make sure that the mains plug is clean and in a good
condition.
CAUTION
Do not operate the device together with other devices
on an extension cable with multiple power sockets.
Description of the device
Device overview, front
Illustration B
Steering wheel
1
Fresh water tank automatic filling system
2
pre-sweeping unit hood***
3
Side brushes*
4
Driving motor
5
Squeegee blade holder
6
Squeegee blade
7
Suction bar
8
* Optional
*** Combo variant only
Device overview, rear
Illustration A
Overhead guard*
1
Flashing beacon*
2
Blue spotlight rear/ front*
3
Suction lance for DOSE detergent dosing unit*
4
Waste water tank cap
5
Fresh water drain hose
6
Waste water drain hose
7
Manual tank cleaning - spray gun
8
Suction hose
9
Suction beam ram protection*
10
Waste water tank inspection opening
11
Waste container***
12
Fresh water lid
13
Control panel
14
* Optional
*** Combo variant only
English
Device overview, seat
Illustration C
Detergent tray for DOSE detergent dosing unit*
1
Seat
2
Steering wheel knob
3
Weight adjustment lever
4
Seat length adjustment lever
5
* Optional
Device overview, waste water tank
Illustration D
Waste water tank support
1
Float
2
Waste water impact protection
3
Waste water tank cap
4
Coarse dirt basket
5
Turbine pre-filter
6
Waste water tank
7
Device overview, pedals
Illustration AP
Coarse dirt flap pedal
1
Brake pedal
2
Accelerator pedal
3
Device overview, pre-sweeping unit
Illustration E
Filter housing cover
1
pre-sweeping unit hood***
2
Side brushes***
3
Filter housing
4
Sweep container
5
*** Combo variant only
Type plate
Illustration AJ
Type plate
1
Control panel
Illustration F
Program switch
1
Display
2
QR code for the how-to video
3
Info button for menu navigation in the display
4
Driving direction switch
5
2-stage horn
6
Cleaning solution ON/OFF
7
Side brush/side scrubbing deck ON/OFF (side
8
brush option with Combo variant)
Intelligent key
9
Maximum permissible gradient
10
Safety switch
11
Program switch
Illustration G
0
1
Device is switched off.
Transport journey
2
Drive to the operating location.
Eco program
3
Clean the floor wet (with a reduced water quantity
and a reduced brush speed) and vacuum up waste
water (with reduced suction power).
Scour and vacuum
4
Clean the floor wet and vacuum up waste water.
Increased brush contact pressure
5
Clean the floor wet (with increased brush contact
pressure and increased water quantity) and vacu-
um up the waste water.
Scouring / pre-cleaning without vacuuming
6
Clean the floor wet and let the detergent act.
Vacuuming
7
Vacuum up the dirty liquid.
11