Publicidad
Idiomas disponibles
Idiomas disponibles
ENOW00860-0
CAUTION
Be sure to keep the harness away from the
rotation parts.
6. Be sure to install the stop switch lock
to the stop switch, and attach the stop
switch lanyard securely to the operator
or to the operator's PFD (Personal Flo-
tation Device.)
7. Set the control lever in the Neutral
position.
8. Pull the starter handle slowly until you
feel engagement, keep pulling till you
feel less resistance. Then pull it quickly.
9. After engine starts, do not reinstall fly-
wheel cover and top cowl.
ENOM00518-0
If the choke solenoid fails to
operate (EP and EPT type only)
1. Remove the top cowl.
2. Close the choke plate by finger.
3. Raise the Free accel lever a little.
4. Turn the main switch key to start posi-
tion.
5. Stop pushing the key when the engine
has started.
6. Return the choke plate to open posi-
tion.
ENGINE OPERATION
1. Choke plate (open position)
1. Choke plate (closed position)
ENOM00043-A
3. Warming up the engine
ENOW00932-0
CAUTION
Be sure to check that cooling water is
coming out of the cooling water check port
during warm up.
Warm the engine at low engine speeds for
about
3 minutes : above 41°F (5
5 minutes at 2000 rpm : blow 41°F (5
This allows the lubricating oil to circulate to
all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
41
1
ENOF00528-0
1
7
ENOF00529-0
)
)
Publicidad
