Yamaha RX-V863 Guia De Inicio Rapido página 100

Remote control features
3
Press 9 k / n to select and enter a character.
Pressing 9 n changes the character as follows:
A to Z, 1 to 9, 0, + (plus), – (hyphen), ; (semicolon),
/ (slash), and space.
Pressing 9 k changes the characters in reverse order.
PRESET/CH
ENTER
A/B/C/D/E
4
Press 9 h to move the cursor to the next
position.
PRESET/CH
ENTER
y
Press 9 l to move the cursor to the previous position.
Press 9 ENTER to set the new name.
5
"OK" appears in the display window ( 6 ) on the
remote control if renaming was successful.
"NG" appears in the display window ( 6 ) on the
remote control if renaming was unsuccessful. In this
case, start over from step 3.
y
If you continuously want to rename another control area,
press the input selector button ( 5 ), or press
6 SELECT k / n repeatedly to select the component, then
repeat steps 3 through 5.
Press C RENAME again to exit the renaming
6
mode.
RENAME
Note
"ERROR" appears in the display window ( 6 ) on the remote
control if you press a button not indicated in the respective step,
or when you press more than one button simultaneously.
98
En
A/B/C/D/E
Macro programming features
The macro programming feature makes it possible to
perform a series of operations with the press of a single
button. For example, when you want to play a CD,
normally you would turn on the components, select the
CD input, and press the play button to start playback. The
macro programming feature lets you perform all of these
operations simply by pressing the CD macro button. The
buttons listed as macro buttons below are factory set with
macro programs. You can also program your own macros
(see page 100).
■ MACRO operations
Macro buttons
POWER POWER STANDBY POWER
TV AV
SCENE
1 2 3 4
TUNER
A B C
V-AUX/DOCK DTV/CBL CD MD/CD-R
DVD DVR VCR PHONO
MACRO ON/OFF
Set the C MACRO ON/OFF selector to ON.
1
OFF ON
2
Press the desired macro button.
Set the C MACRO ON/OFF selector to OFF
3
when you finish to using the macro
programming operation.
OFF ON
Notes
• While the remote control is running a macro program, it does
not accept any other operation until it has completed running
the program (the transmission indicator stops flashing).
• Continue to aim the remote control at the component the macro
is operating until the macro operation is complete.
INFO EON MODE- PTY SEEK- START
REC
OFF ON MACRO LEARN CLEAR RENAME
MACRO
MACRO LEARN CLEAR
MACRO LEARN CLEAR